King Sun PCB

Back Board Routing Topology

Back board routing topology included Centralized Switching,Distributed Switching,Hybrid Switching,Holst/Slave Switching.

            Centralized Switching

Distributed Switching

Hybrid Switching

Host/Slave Switching

The Structure of Back Board

VITA standard required the dimension of back board,tooling hole position and size,direction,each solt,and case heat dissipation etc.

Back Board Connector

Back Board use MULTIGIG RT connector,the pin of connector includes power, single signal,differential signal.the speed of differential is 10Gbps.

Back Board stack up design

Follow the signal speed to choose material. Design PCB stack up according board thickness and impedance requirement.For example: VPX Back Board, use TU-752 material,4mm board thickness,18 Layers, Layer stack up like below:

Layout Rule

Back board layout is BUS layout,each group trace don’t across and smooth. Highlight each BUS is better for planing.

Equate length

For high speed differential trace,required trace equate length.

Power Design

The main power +12V,+5V,ensure current is adequate when design.

Anti-Pad design

For the vias of certain layer stack up,impact impedance factors includes vias size,pad size, anti-pad size, Stub length,ground vias position etc.

Standard and requirement

For example VITA68:

      Insertion Loss (IL)

      Fitted Attenuation (FA)

      Insertion Loss Deviation (ILD)

      Return Loss (RL)

      Insertion Loss to Crosstalk Ratio (ICR)

      Intra-pair skew

     Lane-lane skew

For example: RapidIO