It’s important to know factors affecting of PTH throwing power to electronics products, then improve high aspect ratio for facilitating productivity.it’s good for electronics products reliability,reduce fabrication cost,improve productivity.
PTH
Plated through hole(PTH) is the crucial process of PCB manufacture. it need be plated enough copper in wall of hole for connect different layers. The copper thickness is very critical for good PCB.
Throwing Power(TP)
Even-plated of through hole is a important factor to adjudge PTH. we call it throwing power,It’s the ratio of plated copper thickness between center point to edge of hole.
Aspect ratio
Throwing power is always relative aspect ratio. When aspect ratio is low,it means board thickness is thin and hole is big.it have enough space for ion spreading,power is adequate distribution when plating.so the TP is high. If aspect ratio is high,it occur “dog bone” result, the TP capability is low.
King Sun capability of TP capability.
High TP’s advantage
The plated of hole wall distributed evenly ensure PCB have good reliability and stability in surface Mount Technology and usage, it great increase longevity of products.
Plating process is bottleneck of PCB manufacture.High TP capability can shorten the process time and increase capacity.
TP improved 10% can reduce 10% material consumption and promote international competitive power.
High-frequency PCB and high-speed signal transmission lines should avoid routing at 90 degree corners, which…
Solder defects often delay new product launches,What factors will affect the poor soldering of the…
Why PCB Thermal management is important? For electronic devices, a certain amount of heat will be generated during…
The factors that cause the welding defects of flexible circuit boards have the following three…
How to choose how many layers of boards are used for design and how to…
When the PCB design is completed, the laminate layer is determined, and the PCB board…